Airsoft Vector Optics Maverick Killflash/Protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for Vector Optics Maverick GenII (SCRD-12II).
v4 front:
This new variant has the polycarbonate piece at a slight angle to avoid reflections from the emitter, especially indoors with high illumination levels. Either a friction fit, or use a small dab of glue to hold it in place. The indentation at the front is meant to be at the top of the sight. If it's not when you tighten the piece, you can slightly sand at the side of the threads till it's right.
v3 front:
A2mm polycarbonate piece optionally goes in first, and then the killflash screws on, keeping it firmly in place.
back:
The back mount's only use is for protection. A 2mm polycarbonate piece again goes in, and the ring gets friction-fit. If using in damp environments, it might be a good idea to use some type of glue/insulator between the back cover and the poly piece, and/or between the cover and the sight, to avoid getting humidity inside.
Category: Sport & Outdoors