L bracket spacer for DDR, ITG, PIU arcade pads

This bracket is sized to work on all arcade dance pads that I know of that use an L-bracket sensor arrangement - that being mainline PIU, all gens of DDR (except Solo), and ITG pads.

Version 2 of the models (not yet pictured above - will update soon) has separate versions for PIU/ITG and DDR brackets, as I learned the brackets have slightly different hole spacing and sizing. Please use the correct one for your pad, and don't hesitate to let me know if you struggle with installation - I'd always prefer to know, so that I can improve these models!

This upgrade is especially recommended on DDR pads, where the screw-spacer-washer arrangement will commonly come unscrewed over time, leading to bent screws, scratched brackets, and 3 times as many parts per bracket as is necessary.

Printing in PLA is perfectly fine. A material that's more abrasion-resistant would also potentially be helpful, if your printer can use them effectively. 

Note: during installation, please verify the screwposts make contact with the back of the pad frame on both sides, as seen in the second photo. If one side isn't making contact, the bracket may be on crooked, which could impede gameplay and induce wear.