1 / 7
Screwed oil lubricant bottle cap
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwed cap replacing missing oil bottle small cap on dispenser
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 332
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Maturity: Very good
- 6 prototypes.
- In use since 2022/01.
If you loose the cap of an oil bottle, you can replace it with this screwed cap.
The dispenser material is most of the time made of low surface tension material. Then it is hard to glue the base on the dispenser.
What I do:
- Glue the bottom part with the male thread (Burette-Bouchon-r00e - I3D-1) on the dispenser.
- Secure it with a very small screw on the side. In my case I found some 1.5mm x 4.5mm screws from refurbished electronics in my stock.
Then you only have to screw the cap on it.
Model “Burette-Bouchon-r00f - Large-I3D-1” is for larger dispenser. The base is about 13mm. The cap is the same.
Log:
- 2025/03/24 : Add a larger adapter (Burette-Bouchon-r00f - Large-I3D-1)