iButton F5 keychain holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple iButton keychain holder for chip size F5 (that's 17.35mm in diameter).
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 328
- Wydruki
- 4
- Wyświetlenia
- 1286
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
It is quite common that the holders of these chips break and the chip no longer holds well in them. This is a simple 3D printing solution.
Inserting and taking out the chip:
1/ Insert the chip all the way to the end of the holder and under the edge.
2/ Bend the entire holder so the chip hole opens a bit.
3/ While the holder is bent, push the chip hard in under the edge.
4/ To take the chip out just bend the holder again and push it through the back side opening.
Printing: Please use PETG due to its flexibility. For example 0.2mm layer, 3 perimeters, 15% infill. See 3mf file.
Also check out: