iButton F5 keychain holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple iButton keychain holder for chip size F5 (that's 17.35mm in diameter).
- Rating
- 5 / 5
- Likes
- 32
- Downloads
- 328
- Makes
- 4
- Views
- 1,286
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
It is quite common that the holders of these chips break and the chip no longer holds well in them. This is a simple 3D printing solution.
Inserting and taking out the chip:
1/ Insert the chip all the way to the end of the holder and under the edge.
2/ Bend the entire holder so the chip hole opens a bit.
3/ While the holder is bent, push the chip hard in under the edge.
4/ To take the chip out just bend the holder again and push it through the back side opening.
Printing: Please use PETG due to its flexibility. For example 0.2mm layer, 3 perimeters, 15% infill. See 3mf file.
Also check out: