Parametrised Power Strip Mount with Rounded Corners
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added rounded corners and a power switch cut out
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 110
- Wydruki
- 4
- Wyświetlenia
- 477
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
This is a fully parametrised mount for power strips, but it will fit any other rectangular thing you want to mount on a flat surface.
To customise, you will need OpenScad and the dimensions of your power strip (just measure them but account for a little clearance, .5mm worked for me). Then get the .scad file, open it and fill in your dimensions at the top. Make sure the mount is not to wide, so it will not cover any power sockets and make sure the power cord will fit through the hole (there are parameters for those dimensions, too). All dimensions are in millimetres.
This is a remix of “Parametrized Power Strip Mount" by jodoll that adds more rounded corners as well as the possibility to make a cut-out for a power switch. You can print the model with the power switch cut-out also for the other side or strips that do not have a switch.