Linus Tech Tips 40 Oz Bottle Cap Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My LTT Bottle Cap broke. These parts work together to keep the cap attached to the bottle.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 771
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So, the spout lid of my LTT 40 Oz water bottle broke. This design attaches securely to both the cap itself, and the body of the bottle. You then use paracord to attach the two pieces together, and the cap is now secured to the bottle. You can also carry the bottle form the paracord. Needs M4 screws and nuts. Mine were torx, yours don't need to be. Length is 20mm on the screws. Print with supports at 100% infill. I used PLA.
Update 11-16-2022: I re-printed the parts in PETG, at 100% infill and test fit them on the LTT 64 OZ bottle. It fits perfectly, just as it did with the 40 Oz. I would, however, recommend using loctite for the nuts and bolts as i did have an issue with them backing out and not securing the bottle together properly.