ROV Kort Nozzle for Bilge Pump Thruster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Kort Nozzle for a homemade ROV thruster made from a Mayfair 750 GPH Bilge Pump. Adding this kort nozzle to…
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 112
- Wydruki
- 1
- Wyświetlenia
- 1171
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Kort Nozzle for a homemade ROV thruster made from a Mayfair 750 GPH Bilge Pump.
Adding this kort nozzle to the thruster will increase the output thrust by about a full pound. This nozzle was specifically design to work with a 3 blade 50mm Robbe Boat propeller using an adapter with these specs.
This was a prototype and the nozzle arms are a little weak so I have since made a new version. that incorporates a mount into the nozzle. This version works for upgrading existing thrusters so I thought I'd share it too.
This nozzle was specifically design to work with a 3 blade 50mm Robbe Boat propeller using an adapter with these specs.
Print Settings
Printer Brand:
MakerGear
Printer:
M2
Rafts:
No
Supports:
Yes
Resolution:
.20
Infill:
100%
Notes:
STL prints as positioned with minimal supports. Even printed at 100% this will probably not be waterproof so keep that in mind when it comes to your Rov's buoyancy.
Custom Section
The kort nozzle/thruster combo was designed to be mounted using a 1 1/2 conduit clamp.
The conduit strap is mounted to the Rov frame using a #12 stainless steel flat head screws. Using a flat head screw allows the mount to self center to the mounting hole.
It can be mounted to a flat or round surface, (PVC frame in this case) the area around the nozzle must remain open though for proper flow.
Category: Robotics