Rostock Carriage Igus/Traxxas - Alternative mounting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Remix of the Rostock Carriage Igus/Traxxas mod. I modified it for several reasons: fit my universal endstop-holder (…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A Remix of the Rostock Carriage Igus/Traxxas mod.
I modified it for several reasons:
- fit my universal endstop-holder ( http://www.thingiverse.com/thing:471761 )
- i dont like these "grid-style" belt mountings. they break of easily and doesn’t provide a nice fit; 2 screws with a clip-holder makes more sense to me.
- front belt-mount; some designs like "zam kossel alt" require this, but there are not many Rostock front-belt designs out there.
the endstop-screw is - looking on the top - moved closer to the center between the smooth rods and not far in front of like in most other designs. on some rostock designs this is easier to mount, especially, when you have to front-mount your belts.
i also slightly enlarged the hex-nut holes. when they are to tight, the material tends to break when tightening the screws.
the clamp should prevent the belts from putting to much force to the carriage and loosening it. It is not just a desing feature, if the belt is tighten properly, it WILL pull the screws outwards a bit and loosening itself, even with washers and if screwed tight!
Instructions
printed with .5 nozzle, .3 layer height and 25% infill @60mm/s
Category: Other