Gridfinity Magnet Base 6x2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glue or press fit magnets into gridfinity bases. Uses qty (8) 6x2mm magnets. ensures same polarity.
- Ocena
- 4,667 / 5
- Polubienia
- 32
- Pobrania
- 210
- Wydruki
- 4
- Wyświetlenia
- 2113
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This remix has qty (8) 6x2mm magnets embedded in the print. You can drop magnets on here, and they snap to the correct spot. This also ensures all the magnets are the same polarity across all your gridfinity projects. I wanted to embed them so i didnt have to worry about these coming out. Since there are 8x magnets total, the rear is magnetic and can stick to a toolbox.
I prefer the press fit gridfinity bins and avoid using glue to set the magnets in place. I use bins with a 6mm hole, 3mm deep. This jig is thick enough to press fit the magnets into the bases.
the stl had some errors, so do not try to “fix through netfabb.” That will remove the magnet holes. The step file loads error free, so i uploaded that.