Rimfire Pistol Maintenance Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a stand to help install the Volquartsen Accurizing kit and aid with basic maintenance on my Ruger Mark 4 22/45.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 132
- Wydruki
- 0
- Wyświetlenia
- 1470
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed and printed this after seeing that similar stands were $20 and still required a vise. I don't have a vise, so I took some measurements and made a stand that holds the gun up by the magwell. The tip of this sits on the mag release of my Mark 4 22/45.
This "should" fit any Ruger Mark 3 or 4 pistol, standard or 22/45, Browning Buckmarks and maybe the SW Victory. Let me know if this fits or doesn't fit something else and I will add/remove it from the list.
I will probably add a slip on cover that fits my other pistols in the near future.
Print Settings:
- Printed in Prusament PLA
- 215C
- 0.20mm
- Quality preset
- 4 perimeters
- 7 top and bottom layers
- 25% cubic infill.
Notes: Tolerances are 0.2-0.3mm so it's a somewhat snug fit. I would recommend printing each piece individually to reduce chances of edge lifting.
PRINT FLAT ON THEIR SIDES, I don't think I have the STL orientation correct for printing, so you will need to change that or use my 3mf.