Monacore WG-300 / DT-254 adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter allow you to use the Monacore WG-300 on the Monacore DT-254. Wrong version? This is for the newer…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter allow you to use the Monacore WG-300 on the Monacore DT-254.
Wrong version?
This is for the newer (plugged) version of the DT-254.
If you need an adapter for the older (three torx screws) version you can use this STL designed by Alexander Heißmann.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
50%
Filament: Janbex PLA Orange
Notes:
The STL file was rendered for a 0.2mm resolution. If you want to use an other you can change the printing resolution in the .scad file. This is mostly the only thing you have to edit.
Please do not select the infill too low, otherwise the adapter will resonate later.The support is only needed for the screw holes.
Custom Section
Prototyping...
Category: Music