1 / 6
Belt Tension Gauge With Weight
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A reasonably accurate tool and method that can be used to gauge the tension on your CoreXY printer's belts.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 1182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
Inspired by this belt gauge by Tom Anderson. My solution addresses the problem of consistent reference tension by adding an adjustable weight. The weight is a bottle filled with water. The water bottle weight is easy to adjust by using a spray bottle to add more water and a cheap $10 kitchen scale to measure the weight accurately. Here is a brief summary of the steps needed to use the gauge:
- Using a kitchen scale and spray bottle, set the total weight of the tool to 200g. Note depending on your printer this might be different but this should be a workable starting point.
- Lock the X gantry and X carriage so that both belts of your CoreXY are the same length. and won't move when the tool is applied. The X carriage clamp I include below was designed for my BLV Cube CoreXY printer.
- Measure the center line for your longest belt runs. Left and right sides of my printer.
- Put the printer on its side if your belts are vertically oriented (See pictures).
- Attach the gauge, including the weight, and adjust the belt tension until the belt appears in the middle of the gauge.
- Repeat for your other belt.