Berkey Royal Water Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
This is designed to raise the Berkey Royal Water Filter a little and let it sit over the lip of our kitchen sink. This helps the spout to stick out over the sink a little more and be just high enough to make filling cups easier. It also gets the spout just high enough to avoid a lot of our dish washing splashes.
This is my very first 3D model design. I created this in Onshape and am also trying out Fusion 360 to see which program is easier for me to use.
I printed this at .28 layer height in PETG with 25% cubic infill. 15% or more infill should be enough but I wanted to make sure I could stand on it to prove to my wife it was strong enough to support a full Berkey without issue. I used PETG to handle the occasional hot water or coffee spills that could happen around it.