iPhone 14 Pro Slim Bumper Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An iPhone 14 Pro Slim Bumper Case
- Ocena
- 5 / 5
- Polubienia
- 69
- Pobrania
- 725
- Wydruki
- 3
- Wyświetlenia
- 4524
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
I have got myself an iPhone 14 Pro. Naturally I need to make this, just like 2 years ago ;)
I added two cat ears to make sure when set on a flat surface, the cameras will have a 0.5mm clearance, and the entire phone doesn't teeter-totter XD
----------------------
To install, fit the top two corners in first, then one of the bottom corner, then force the last corner and push it in. It's a snap-in design so you have to force it.
----------------------
Slicer Settings
In order to successfully print this one, here are some of my suggested slicer settings:
- Layer height: 0.16mm (you can go from 0.12 to 0.2mm)
- Support Pattern: Zig Zag
- Support Wall Line Count: 0
- Support Infill Line Directions: [45]
- Enable Support Brim: Yes
- Support Brim Width: 4mm
The support settings is to make sure the support is easy to remove, still retains its integrity, while prints relatively fast. Otherwise with a support that's too strong, you risk damaging the print itself.
Make sure the long sides are on the less-ripply side of your printer, unless you wanna see more ripples on a big surface every day.
