iPhone 14 Pro Slim Bumper Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An iPhone 14 Pro Slim Bumper Case
- Rating
- 5 / 5
- Likes
- 69
- Downloads
- 725
- Makes
- 3
- Views
- 4,524
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
I have got myself an iPhone 14 Pro. Naturally I need to make this, just like 2 years ago ;)
I added two cat ears to make sure when set on a flat surface, the cameras will have a 0.5mm clearance, and the entire phone doesn't teeter-totter XD
----------------------
To install, fit the top two corners in first, then one of the bottom corner, then force the last corner and push it in. It's a snap-in design so you have to force it.
----------------------
Slicer Settings
In order to successfully print this one, here are some of my suggested slicer settings:
- Layer height: 0.16mm (you can go from 0.12 to 0.2mm)
- Support Pattern: Zig Zag
- Support Wall Line Count: 0
- Support Infill Line Directions: [45]
- Enable Support Brim: Yes
- Support Brim Width: 4mm
The support settings is to make sure the support is easy to remove, still retains its integrity, while prints relatively fast. Otherwise with a support that's too strong, you risk damaging the print itself.
Make sure the long sides are on the less-ripply side of your printer, unless you wanna see more ripples on a big surface every day.
