Stickvise jaws for MHP30
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement jaws for a stickvise that hold a pcb at the right high for an MHP30 hotplate preheater
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 701
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
These are replacement stickvise jaws that you can use to hold a PCB at the correct height for use with the Miniware MHP30!
I generated them with the official stickvise jaws OpenSCAD script, which is available here: https://www.stickvise.com/hacks/parametric-jaws
Note that your PCB will get very hot when it is being heated, so choose your print material appropriately! Definitely not PLA! Personally, I used ABS and then covered each jaw in a layer of polymide tape, followed by a layer of copper tape. Hopefully this will be enough for the jaws to take the heat, but if you do this and it all melts into a big mess then it's not my fault!!
For assembly, you can just reuse the bolts that hold on the original jaws. You will need a long screwdriver though.