Stickvise jaws for MHP30
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement jaws for a stickvise that hold a pcb at the right high for an MHP30 hotplate preheater
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 30
- Makes
- 1
- Views
- 701
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Public Domain
These are replacement stickvise jaws that you can use to hold a PCB at the correct height for use with the Miniware MHP30!
I generated them with the official stickvise jaws OpenSCAD script, which is available here: https://www.stickvise.com/hacks/parametric-jaws
Note that your PCB will get very hot when it is being heated, so choose your print material appropriately! Definitely not PLA! Personally, I used ABS and then covered each jaw in a layer of polymide tape, followed by a layer of copper tape. Hopefully this will be enough for the jaws to take the heat, but if you do this and it all melts into a big mess then it's not my fault!!
For assembly, you can just reuse the bolts that hold on the original jaws. You will need a long screwdriver though.