Soda Stream Air Gun - A Simpler Version

Often your SodaStream bottle will have some CO2 remaining near the end of it's use. You can use this model to put that CO2 to use as a air duster. 

*** Caution - The air in the CO2 canister is high pressure.  Use this model at your own risk ***

*** Caution - Always wear eye protection ***

This version of the Soda Stream Air Gun requires the following.

• Two 2.4mm pins (I used the metal from two rivets)
• A Dust Blaster 3mm tube
• Teflon Tape (Optional)

Instructions

• Print the lever model on it's side
• Print the model that attaches to the canister upside down with support
• Clean up the support and make sure that the support has been removed from all holes
• Ensure that the parts fit together and move freely
• Cut one pin to be used to release the CO2. Warning making the pin too long will release too much gas. Use a length that is safe.
• Cut another pin to be used to connect the lever with the base ~38mm
• Place the pin in the hole used to release the gas. Make sure that it moves freely
• Assemble the lever and the base and place the pivot pin through the two parts. You may need to use a hammer
• Apply the Teflon Tape if you want a tighter seal (Optional)
• Screw the assembled air gun on to the CO2 Soda Stream bottle
• Place the Dust Blaster tube in the hole that the air will flow through
• The air gun is now ready to use
• Engage the lever to release the gas. The spring in the CO2 bottle should push the pin back up when the lever is released
•  Be careful the gas is highly pressurized!

Printing

• .2mm layer height
• .4mm nozzel
• 100% infill
• Requires support 

Happy Dusting

Soloo