1 / 7

Soda Stream Air Gun - A Simpler Version

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simpler version of the SodaStream air gun. Use the remaining CO2 in your Soda Stream bottle as an air duster!

Updated at source: Sep 22, 2022

Model information

Often your SodaStream bottle will have some CO2 remaining near the end of it's use. You can use this model to put that CO2 to use as a air duster.

*** Caution - The air in the CO2 canister is high pressure. Use this model at your own risk ***

*** Caution - Always wear eye protection ***

This version of the Soda Stream Air Gun requires the following.

Instructions

Print the lever model on it's side
Print the model that attaches to the canister upside down with support
Clean up the support and make sure that the support has been removed from all holes
Ensure that the parts fit together and move freely
Cut one pin to be used to release the CO2. Warning making the pin too long will release too much gas. Use a length that is safe.
Cut another pin to be used to connect the lever with the base ~38mm
Place the pin in the hole used to release the gas. Make sure that it moves freely
Assemble the lever and the base and place the pivot pin through the two parts. You may need to use a hammer
Apply the Teflon Tape if you want a tighter seal (Optional)
Screw the assembled air gun on to the CO2 Soda Stream bottle
Place the Dust Blaster tube in the hole that the air will flow through
The air gun is now ready to use
Engage the lever to release the gas. The spring in the CO2 bottle should push the pin back up when the lever is released
Be careful the gas is highly pressurized!

Printing

Happy Dusting

Soloo