Anycubic Mega Zero 2nd Z Leadscrew Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my dimensionally accurate, (after many iterations & fails), of the left rear mount required when upgrading to…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is my dimensionally accurate, (after many iterations & fails), of the left rear mount required when upgrading to a dual Z axis configuration.
I have also included the stepper bracket as mine was modelled using a thinner than the standard OE stepper bracket that is fitted on the right side.
If fitting to the MZ2 the PSU will need to be relocated, I have mine free standing now for ease.
Even though there seem a lot of these second Z mounts out there, they are mostly, (99.9%), designed around the Creality printers, which have different screw spacings to the Mega Zero & will cause binding, I know, I've been there done that.
Designed for 0.2mm LH
I use 100% fill for strength & use PLA
Print Settings
Printer:
Anycubic MZ2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
100
Filament:
Sunlu PLA
any
Category: 3D Printer Parts