Phaser (TOS Type II) in two pieces for printing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Phaser model that is the parent looked good but also looked like a support nightmare. I resized it a bit and split…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 634
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
The Phaser model that is the parent looked good but also looked like a support nightmare. I resized it a bit and split it so you could print the halves and glue them together.
Instructions
Print both halves. Glue together.
There are three files: one plate and then both sides separate.
Watch out for warping! The barrel doesn't have a lot of contact area and if it warps it won't fit together well. I may try printing with a brim.
The 50% sized print did pretty well on fitting together.
Category: Props