1 / 5
Phaser (TOS Type II) in two pieces for printing
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Phaser model that is the parent looked good but also looked like a support nightmare. I resized it a bit and split…
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 88
- Makes
- 0
- Views
- 634
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Share Alike
The Phaser model that is the parent looked good but also looked like a support nightmare. I resized it a bit and split it so you could print the halves and glue them together.
Instructions
Print both halves. Glue together.
There are three files: one plate and then both sides separate.
Watch out for warping! The barrel doesn't have a lot of contact area and if it warps it won't fit together well. I may try printing with a brim.
The 50% sized print did pretty well on fitting together.
Category: Props