Bit-Holder for cordless screwdriver (Bosch)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holder can be mounted on the back of a cordless screwdriver. The bits are held by magnets which are located…
- Ocena
- 4 / 5
- Polubienia
- 25
- Pobrania
- 118
- Wydruki
- 3
- Wyświetlenia
- 1366
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This holder can be mounted on the back of a cordless screwdriver. The bits are held by magnets which are located inside the 3d printed part, also the nut for the screw is located inside the part.
To insert the nut and magnets, the print must be paused before the placeholders are closed by the upper layer. I added a filament-change at those positions (M600 gcode command) and then replaced the M600 command by the following commands:
M300; beep G1 X10.000 Y200.000 E0; parking position, push forward the bed M1; user stop G28 Y; home y if you need to remove some filament from nozzle M105; return to current temp
Since the magnets are pulled out of the holes by the metal parts of the nozzle, I fixed them with a drop of super glue.
The nut used is an M5 nut (4 mm thick).
The screw used is an M5x20.
The magnets used have a diameter of 6 mm and a thickness of 3 mm.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.15mm
Infill:
15%
Filament: Purefil PLA anthrazit
Notes:
Do not forget to stop the print at the moment when you have to insert the magnets or the nut!
Category: Tool Holders & Boxes