valorant butterfly balisong trainer knife with bushing pivot and zen pin system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
balisong trainer from valorant
- Ocena
- 4,5 / 5
- Polubienia
- 73
- Pobrania
- 314
- Wydruki
- 2
- Wyświetlenia
- 3693
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is fully flippable balisong knife with bushing and zen pinless design. Weight of printed parts - cca 40 grams, with aditional wight in handles 50 grams. Lenght of whole opened knife is 257mm and closed 145mm.
needed parts:
blade - 1x (with or without holes for nuts)
handle frame - 2x
handle1 - 2x
handle2 - 2x
bushing - 2x
washers - 4x (optional - basic M3 washers will do better - two sizes due to printers imperfections)
non printable parts:
M3 screw - 2x (i dont know the lenght, i just nipped them to the right lenght)
M3 nuts - minimal 2x (for the pivots)
M3 washers - 4x
M3 lock washers - 2x (you can instead use locktite, doesn´t matter)
rubber bands - 2x optional
M2 screw - 12x (optional - only on ´´handle1, handle2´´)
print settings:
layer height - 0,2 mm
layer width - 0,4 mm
top/bottom layers - 5
wall account - 5
infill - 15%
The big hole in handle frame is for aditional weight. I put there one big screw and the leftover space was filled with gluegun. The groove on the end of the handle is for rubberband for better sound.