Ammonite Trailer Hitch Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ammonite cover for a 1.25-inch trailer hitch.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 579
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
An ammonite fossil trailer hitch cover. 1.25-inch square, and 5.5cm depth to the tabs. No additional parts are necessary: the included tabs have enough spring action to fill the holes in the side of the hitch.
Print in PETG or some other higher melting point material: PLA will melt in the sun!
I printed it with the fossil on top, using a lot of supports. Printing fossil down will require fewer support material, but you may need to do some sanding afterwards, which could be tricky with this surface.
This is a simple mix of the ammonite from https://www.thingiverse.com/thing:88025 by Museum Victoria, and the trailer hitch cover from https://www.thingiverse.com/thing:4831452 by dmccombs. The TinkerCAD project is available at https://www.tinkercad.com/things/38JZPaQTAc5-amazing-inari-uusam/edit?sharecode=MEkV9zpuILldhEmkcFI4H-E0qyMJp2t9bswG2CDPm5c.