BambuLab X1C Poop Chute
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is designed to catch the flushed(poop) pellets from X1C from out the back of the printer and guide them to the left
- Ocena
- 5 / 5
- Polubienia
- 54
- Pobrania
- 287
- Wydruki
- 1
- Wyświetlenia
- 8991
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a "Poop Chute" designed for the Bambu Labs X1 Carbon with AMS Printer. The Printer has a built in Purge Slide that ejects pellets out the back of the printer. This Version 5 Design is the final version. There is an inset area to glue a magnet to hold the chute in place.
Version 5 Now reaches all the way to the left side edge of printer! Widened 50mm, Lowered the catch bin 5mm, inset the legs into the bottom side so you can print flat on the bottom without supports.
Printer:
Bambu X1 Carbon
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
15%
Notes:
Can be printed in any filament. Stand alone object or could be secured with magnet strips to back of printer. If your printer cannot bridge 15mm then you can always add supports inside the chute and between the leg post hole bases.
Post-Printing:
Add a flat magnet to in the inset area to prevent the vibrations from moving the chute. You may need to sand the top posts on the legs lightly if your printer calibration and flow control are not good!