Poor man's piggyback ISP
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connect male Dupont pins to a DIP-packaged IC's pins on the fly. Mainly meant for in-system-programming (ISP).
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 394
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use this quick print adapter to connect male Dupont pins to a DIP-packaged IC's pins on the fly.
Meant for in-system-programming (ISP) AVR microcontrollers, but surely there are other uses, e.g. in-circuit testing with logic analyzers etc.
Comes in versions for 8, 14, 16, 20 and 28 pin DIP packages. Write in the comments or send me a message if you need others.
Usage:
Simply clip it on top of your PCB mounted IC and push in your Dupont connectors wires where you need them. You'll need a tiny bit of force, as the adapter is designed to firmly press the contacts against each other. That's why I don't recommend using plain jumper wires, they are often too feeble and will slide out of their housing.
Important: Be careful upon removal of the adapter, or you might remove the IC with it (and bend its legs etc.). Best use a wedge shaped tool like pincers and gently push it in between the top of the IC and the adapter, working from both ends until it pops off.
Print Settings
Printer:
Creality Ender 3 v2
Rafts:
No
Supports:
No
Resolution:
.12mm
Infill:
100%
Filament:
any any
any
Notes:
There's little room for tolerances as we need to get a tight, but not too tight, contact between Dupont and IC pins.
So if you're print comes out too loose or too tight, play around with the usual settings like*Hole horizontal expansion*, flow rate etc. to adapt the holes' widths.Category: Electronics