Divided Drawer and under desk mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added partitions to the drawer and countersunk screw holes
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 386
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Thanks to Heine Sorensen for posting the original drawer model after posting their mod for Were screwdrivers here:
https://www.printables.com/model/219770-wera-micro-screwdriver-under-drawer
I needed a drawer for coins I use to pay for my meals (need 15 cents per day, and I have been going through a lot of pennies and others to pay a portion of the cost), so I added two walls to the excellent drawer design and printed them in red PLA.
I created supports for the drawer handle, but I suspect they are not needed. Infill doesn't really matter either, but I did print with five walls for extra strength.
The drawer was printed at .3 mm layer height, and the mount at .2. It is very sturdy.