FabScanPi - Holder for Calibration-Pattern Sheet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an redesigned version of the calibration-pattern holder which is needed for FabScanPi software version 0.4.0.…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an redesigned version of the calibration-pattern holder which is needed for FabScanPi software version 0.4.0. and beyond. It was optimized to reduce printing time and material consumption.
There is also a version for the FabScanPi SandwichBox. For that one you will need an M5 x 16 screw, washer and nut. And one M3 x 16 screw, washer and nut. Because it's adjustable design you can probably use it on you own design of the turntable. To use it you'll need to remove one of the turntable's four fixing screws.
Category: 3D Printing