1 / 7
FabScanPi / RaspiCam adjustable Camera Mounting
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a adjustable camera holder for the 3D Scanner FabScanPi (Model 2016 - ) The standard camera is the RaspberryPi…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a adjustable camera holder for the 3D Scanner FabScanPi (Model 2016 - )
The standard camera is the RaspberryPi Cam V1.x or V2.x
You can adjust the x- and y-Axis (about +/- 1 cm) and you can correct the angle by adjusting the three mounting screws at the backside.
Optional you can print "Sled I LED" so that you can also use the "RPi-RingLicht" Board.
Post-Printing
BoM - Bill of Materials
To build the camera mounting you'll need the follwing parts:
##### to be printed:- 1 x Sled I (Camera) or 1x Sled 1 LED (with LED Board)
- 1 x Sled II (Frame)
- 1 x Sled III (Rearpanel)
additional parts (vitamins):
- 2 x Screw M3 x 40mm
- 5 x Nut M3
- 4 x brass shaft, length: 53mm
- 4 x pressure spring (from a ball pen / biro)
- 4 x Screw M 2,5 x 6mm
Category: Parts