1 / 8
Mounting for the 12864 LCD Controlpanel (likewise Sainsmart LCD 2004)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mounting bracket to fix the SainSmart Megatronics LCD12864 onto Mendel style printers Fits on: Mendel-Style…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a mounting bracket to fix the SainSmart Megatronics LCD12864 onto Mendel style printers
Fits on:
- Mendel-Style printer (M8 threaded-rod frame)
- Mendelmax printer
- others...
Instructions
Mendel
Print the three parts
- Holder (for standard M8 hex head screw OR cylinder head screw)
- Nutholder
- End (for standard M3 hex head screw OR cylinder head screw)
Buy Vitamins / additional parts:
- 1 M8 x 120 cylinder head screw (or standard hex head cap screw with washer)
- 1 M8 nut
- 1 M8 spring washer
- 2 M3 x 20 cylinder head screws (or M3 x 25 with philips machine head)
- 2 M3 nuts
Assemble the parts
- Put the M8 screw in the holder (there is a bigger hole for the cylinder head at the left side of the mouting).
- Put the spring washer on the threaded end of the screw.
- M8 nut and M3 nuts go into the specific holes of the nut holder part.
- Connect mounting and Nut holder with the M8 screw.
- Put the free end of the nut holder on a threaded rod of your printer. Put the end part from the other side of the threaded rod and fix the mounting-nut-holder and the end part with two M3 screws.
- Finally you can tighten the M8 screw so that the angle of the display can be changed by hand.
Mendelmax
Print two parts
- Holder (for standard M8 hex head screw OR cylinder head screw)
- Nutholder for Mendelmax
Buy Vitamins / additional parts:
- 1 M8 x 120 cylinder head screw (or standard hex head cap screw with washer)
- 1 M8 nut
- 1 M8 spring washer
- 2 M5 x 16 cylinder head screws
- 2 M5 washers
- 2 M5 T-Slot nuts
Assemble the parts
- Put the M8 screw in the holder (there is a bigger hole for the cylinder head at the left side of the mouting).
- Put the spring washer on the threaded end of the screw.
- Connect mounting and Nut holder with the M8 screw.
- Attach the Nut holder to the printerframe by using 2x M5 screws and T-Slot nuts.
- Finally you can tighten the M8 screw so that the angle of the display can be changed by hand.
Category: 3D Printer Accessories