1 / 1
Rasberry Pi Camera Bed Mount for Prusa MK2.5S (lengthened) — zdjęcie 1

Rasberry Pi Camera Bed Mount for Prusa MK2.5S (lengthened)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Based on jgeyer's mount, and made the following changes Lengthened by 10mm to clear the angled print fan of MK2.5 and…

Ocena
0 / 5
Polubienia
1
Pobrania
14
Wydruki
0
Wyświetlenia
456
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Based on jgeyer's mount, and made the following changes

  1. Lengthened by 10mm to clear the angled print fan of MK2.5 and MK2.5S
  2. Enlarge bottom hole where heat bed screw-head fit in, to avoid heat bed screw getting stuck during uninstallation.
  3. Limited chamfer to 45 deg for no overhang
  4. Adjusted mouth opening dimension to better fit the heatbed carrier frame, adjusted for overhang.

Print Settings

Supports:

No


Notes:

Recommend at least 0.20mm layer thickness. Print upright where the opening is point to the ceiling.

Post-Printing =============

clear out holes using burr remover or knife.

Category: 3D Printer Accessories

Tagi