100mm pipe endcap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed an endcap to close up a wall through that was no longer needed. And since the home depot was closed already,…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 128
- Wydruki
- 1
- Wyświetlenia
- 645
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I needed an endcap to close up a wall through that was no longer needed. And since the home depot was closed already, I simply printed one to close up the pipe with an ID 95 mm/OD 100 mm. With one to two wraps of ductape, this seals the pipe to cut off any airstream.
I included a small 0.4 mm recess for the pipe to sit in, so the air seal would be a little better without additional sealant, but one could also use it to carry additional sealant.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
10% Gyroid
Filament: Kaisertech PLA white
Notes:
As I printed with gyroid infill and just 3 top/bottom layers, the center also provides a small amount of insulation from the included airgaps.
Category: Parts