100mm pipe endcap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed an endcap to close up a wall through that was no longer needed. And since the home depot was closed already,…
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 128
- Makes
- 1
- Views
- 645
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
I needed an endcap to close up a wall through that was no longer needed. And since the home depot was closed already, I simply printed one to close up the pipe with an ID 95 mm/OD 100 mm. With one to two wraps of ductape, this seals the pipe to cut off any airstream.
I included a small 0.4 mm recess for the pipe to sit in, so the air seal would be a little better without additional sealant, but one could also use it to carry additional sealant.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
10% Gyroid
Filament: Kaisertech PLA white
Notes:
As I printed with gyroid infill and just 3 top/bottom layers, the center also provides a small amount of insulation from the included airgaps.
Category: Parts