Dog Food Can Lid (1.2kg or 100mm diameter)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Avoid brittle PLA's for this, it needs some flex. My Esun PLA+ plus works perfectly.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 249
- Wydruki
- 4
- Wyświetlenia
- 1004
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Avoid brittle PLA's for this, it needs some flex. Snaps on perfectly with this PLA+. Will be uploading another model without the splits for TPU/TPE for a water-tight fit.
Print settings (Cura):
Walls x 3
Top/Bottom x 6
.2mm layer height
4mm width
210c print
60 c bed
60mm/s
Flow 94% (gives me accurate measurements without any signs of under extrusion)
Coasting enabled
Coasting Volume 0.032mm3 (helps remove the seem)
Fan 0% first layer to 100% at layer 3
No brim or skirt needed unless you have terrible bed adhesion. Add a brim or just slow down first layer.
Print Settings
Printer:
Voxelab Aquila S2
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
None
Filament:
eSun PLA+
Orange Post-Printing =============
Category: Containers