1 / 6
20mm Hole Fibre Barrel Holder — zdjęcie 1
1 / 6

20mm Hole Fibre Barrel Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I needed to add another bulkhead to a fibre termination box as I was already using all the outputs.

Ocena
0 / 5
Polubienia
5
Pobrania
19
Wydruki
0
Wyświetlenia
208
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

I needed to add another bulkhead to a fibre termination box as I was already using all the outputs. The termination box had a spare 20mm hole punched into it so I desgned a holder to clip in a fibre barrel that I could then use as another bulkhead.

The outer diameter of the holder ring is 20mm, this should be slightly bigger than the inside diameter of the 20mm hole, a bit of light filing is needed to ensure a snug fit. Once pushed in these are very solid. There is a lip in the adapter to clip the barrel into to hold it securely. A small poking tool will be required to remove the barrel if required.

The STL is attatched.

The design is on tinkercad here: https://www.tinkercad.com/things/7s0Uhm2LhDL-20mm-to-fibre-bulkhead