20mm Hole Fibre Barrel Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed to add another bulkhead to a fibre termination box as I was already using all the outputs.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 19
- Makes
- 0
- Views
- 208
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I needed to add another bulkhead to a fibre termination box as I was already using all the outputs. The termination box had a spare 20mm hole punched into it so I desgned a holder to clip in a fibre barrel that I could then use as another bulkhead.
The outer diameter of the holder ring is 20mm, this should be slightly bigger than the inside diameter of the 20mm hole, a bit of light filing is needed to ensure a snug fit. Once pushed in these are very solid. There is a lip in the adapter to clip the barrel into to hold it securely. A small poking tool will be required to remove the barrel if required.
The STL is attatched.
The design is on tinkercad here: https://www.tinkercad.com/things/7s0Uhm2LhDL-20mm-to-fibre-bulkhead