1 / 1
Wood Pellet Products - Big Timber Patio Heater Key Clip — zdjęcie 1

Wood Pellet Products - Big Timber Patio Heater Key Clip

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you have a Wood Pellet Products Big Timber Patio Heater you may have experienced the "key" which is the shutoff for…

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
1
Wyświetlenia
201
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

If you have a Wood Pellet Products Big Timber Patio Heater you may have experienced the "key" which is the shutoff for the pellets falling out (it only stays in based on friction from the pellets, but it sometimes still falls out). So I built a clip to keep the key in place assuring the shutoff of the heater. In my case I printed it in SLA via a tough resin (formlabs tough 1500) and use VHB tape to attach it, but the model has a hole in case you want to use a self-tapping sheet-metal screw (I didn't want to put that up into the pellet chute. The tough resin (sort of like nylon or PC blend) flexes nicely and so to release just push the little tab on the end of the clip and it fits nicely in when you slide the key into place.

As always I am including the STEP in addition to the 3MF and STL so you can alter it as you need too.

Print Settings

Printer Brand:

Formlabs

Printer:

Formlabs Form 2

Rafts:

No

Supports:

Yes

Resolution:

Adaptive

Infill:

100%

Filament: Formlabs Tough 1500 Grey


Notes:

I actually printed this on the Form 3 not a 2 but that wasn't a choice, and used the latest adaptive tough 1500 profile.

Note if you FDM this it is probably critical to have the part on its side so the layer lines are in the direction of stress which would require supports. I would choose a nylon (PA) or Polycarbonate (PC) to handle the repeated flexing. This part of the heater does not get hot.

Category: Outdoor & Garden

Tagi