CR-10 Smart Filament Sensor Feed Guide V1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some CR-10 Smarts don't come with a guide between the runout sensor and the extruder; this one's better than stock, IMO.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 690
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought a CR-10 Smart and it didn't come with a guide between the extruder motor and the filament runout sensor, so I figured I ought to make one. Has a little window cutout to see that there's filament in there; it doesn't affect feeding.
This should fit the CR-6 SE too, but I don't have one to try.
I recommend printing on its side, with the bigger hole at the bed. You might need to ream the hole out with a 2mm (or 2.5mm, depending on your tolerances) Allen key to let filament pass effectively, but once it snaps in I find that it's very reliable.
Please note: all my Printables models that are not a remix of others' work are licensed CC-BY-NC-SA. Commercial usage is available upon request; please reach out via email.