1 / 2
Skaids Holder: Kimwipes Box, Small (uses heat set inserts) — zdjęcie 1
1 / 2

Skaids Holder: Kimwipes Box, Small (uses heat set inserts)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ikea Skadis holder for a small Kimwipes box, using heat-set inserts and printed hooks for mounting

Ocena
4 / 5
Polubienia
28
Pobrania
59
Wydruki
1
Wyświetlenia
611
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

Skadis holder for small-sized Kimwipes boxes, which are typically 120mm x 120mm x 75mm in size. Designed around the dimensions of Kimwipes part number 34155.

Slightly overengineered to aid in easy, reliable, and rapid repositioning to fit different workspace needs.

This model requires M2.5 heat-set inserts, M2.5 screws, and printed hooks for mounting and M3 heat-set inserts and M3 screws for assembly.

Required Parts

  • Printed hooks
    • See linked project for more details
  • M2.5 heat-set inserts (x4, for mounting)
  • M2.5 screws (x4, for mounting)
  • M3 heat-set inserts (x10, for assembly)
  • M3 screws (x10, for assembly)
    • McMaster Carr 91290A115 (10mm, $9.54, 100 pcs)
      • These fancy black-oxide hex-socket screws fit perfectly flush in the front panel and look great, however any 10mm M3 screws with a head diameter smaller than 5.75mm should work fine 

Design/Assembly Notes

This project requires printing of three parts, in addition to the hooks mentioned above:

  • Base
  • Bottom Plate
  • Top Plate

When assembling, the front plates are likely to be 2-4mm from the risers they screw into. This is by design, since there can be some variability in the actual depth of the cardboard box itself. Chamfers are included in various positions to allow for cardboard box size variations and flexing as well. The result should be a snug, solid fit when assembly is complete.

The tradeoff for this snug fit is that swapping a box out can be a bit of a pain, requiring disassembly and reassembly.

Printing Notes

For printing any heat-set insert project on a FFF/FDM printer its a good idea to use 4+ perimeters to make sure that there's enough surface for the inserts to bite into.

My test and final prints were done on a stock Prusa MINI+ with Prusament PETG. PLA and other materials should work fine though.

Tagi