1 / 1
Danfoss Ally thermostat adapter to Oventrop valve M30x1 — zdjęcie 1

Danfoss Ally thermostat adapter to Oventrop valve M30x1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for radiator thermostat Danfoss Ally. At allows mount the thermostat to old Oventrop valve with M30 x 1 thread.

Ocena
5 / 5
Polubienia
4
Pobrania
100
Wydruki
1
Wyświetlenia
1434
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Print instructions

  • Print with 0,1 mm layer height for sufficient thread quality.
  • Fillament PETG or ASA.
  • 4 outer perimeters.
  • Supports needed. Use cylinder support enforcer with diameter 27 mm. The support must not touch the internal thread (see image). You can also use attached g-code which already contains necessary supports.
     

Mount insructions

  1. Remove all fillament excess from threads.
  2. Screw the adapter onto the radiator valve. If it is difficult, always loosen it, clean the thread and try again. You can use lubricant.
  3. Set your Danfoss Ally thermostat to mount mode pressing button for 3 seconds. M symbol appears on the display.
  4. Screw the thermostat on the adapter until it clicks.

Tagi