1 / 1
Danfoss Ally thermostat adapter to Oventrop valve M30x1
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for radiator thermostat Danfoss Ally. At allows mount the thermostat to old Oventrop valve with M30 x 1 thread.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 100
- Makes
- 1
- Views
- 1,434
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Print instructions
- Print with 0,1 mm layer height for sufficient thread quality.
- Fillament PETG or ASA.
- 4 outer perimeters.
- Supports needed. Use cylinder support enforcer with diameter 27 mm. The support must not touch the internal thread (see image). You can also use attached g-code which already contains necessary supports.
Mount insructions
- Remove all fillament excess from threads.
- Screw the adapter onto the radiator valve. If it is difficult, always loosen it, clean the thread and try again. You can use lubricant.
- Set your Danfoss Ally thermostat to mount mode pressing button for 3 seconds. M symbol appears on the display.
- Screw the thermostat on the adapter until it clicks.