Raymarine mount replacement for phone holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified piece that will attach to this specific Raymarine mount (see pictures).
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 246
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Introduction:
I created this model as I had an older Raymarine mount on my center console boat. I doubt there will be others that find this useful or will be using this exact model or not, though I figure just in case.
There are three models uploaded but only one will be needed. Two have various connections to another 3D model to mount a phone. That model can be found on Thingiverse under thing:5345131. As I only used the standard threads and ball joint (which can be found anywhere), I don't think it fits the bill as a “remix”.
Each of the ends have two mounting holes each that can use M3 screws and nuts. It would be recommended to use washers as most M3 screw heads are a shy to small.
Print Directions:
Nothing fancy. Infill can be whatever you want, in whatever style. The measurements are exact to the holes and the distance, so there should be no need to scale this at all.