1 / 4
Handwheel for 5mm, 6mm, 8mm, 0.25in, 0.4375in, 0.5in etc. — zdjęcie 1
1 / 4

Handwheel for 5mm, 6mm, 8mm, 0.25in, 0.4375in, 0.5in etc.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a set of old machine-tool-style handwheels. As shown: a 50mm ring, 6mm bore, 3 spokes, M3 trap nut, handle.

Ocena
0 / 5
Polubienia
1
Pobrania
64
Wydruki
2
Wyświetlenia
482
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

As shown, the 50mm X 6mm bore is intended for a potentiometer knob on my printer.  It would also work for 6mm rod or threaded rod.  It fits well on the splined potentiometer shaft of my Ender 3V2.

The 50mm X 5mm bore fits on a stepper motor.  (I did ream out my sloppy first print with a 13/16" drill bit)  Per the pic, I didn't have a shorter M3 bolt or grub screw to test assembly inside the rim.

The 50mm X ¼" bore is intended for potentiometers, ¼" rod, or threaded rod.

The 100mm X 7/16" bore handwheel is for an old shop lathe.

The 100mm X ½" bore handwheel is for the shop

There are also models with 0.5mm holes in the middle to use as blanks to be drilled with a drill, or you could use your slicer to infill the hub and slice a custom round or square hole through the center.

The handle is surprisingly strong, but if I have problems with breakage, I might redo it as a separate, replaceable piece to attach with a bolt down its center.

 

Tagi