Handwheel for 5mm, 6mm, 8mm, 0.25in, 0.4375in, 0.5in etc.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a set of old machine-tool-style handwheels. As shown: a 50mm ring, 6mm bore, 3 spokes, M3 trap nut, handle.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 64
- Makes
- 2
- Views
- 482
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
As shown, the 50mm X 6mm bore is intended for a potentiometer knob on my printer. It would also work for 6mm rod or threaded rod. It fits well on the splined potentiometer shaft of my Ender 3V2.
The 50mm X 5mm bore fits on a stepper motor. (I did ream out my sloppy first print with a 13/16" drill bit) Per the pic, I didn't have a shorter M3 bolt or grub screw to test assembly inside the rim.
The 50mm X ¼" bore is intended for potentiometers, ¼" rod, or threaded rod.
The 100mm X 7/16" bore handwheel is for an old shop lathe.
The 100mm X ½" bore handwheel is for the shop
There are also models with 0.5mm holes in the middle to use as blanks to be drilled with a drill, or you could use your slicer to infill the hub and slice a custom round or square hole through the center.
The handle is surprisingly strong, but if I have problems with breakage, I might redo it as a separate, replaceable piece to attach with a bolt down its center.