Watering bottle nozzle spout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a watering spout head designed to fit onto a standard drink bottle thread. All of the watering bottle spouts i…
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 312
- Wydruki
- 3
- Wyświetlenia
- 1305
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This is a watering spout head designed to fit onto a standard drink bottle thread.
All of the watering bottle spouts i could find online had big holes and very small heads, meaning the water would come out very fast in a concentrated area, drowning seedling and throwing up soil.
This watering spout has a large 100mm head and tiny 1mm holes, this gives a thorough shower effect; the water comes out gently and covers a wide area. You'll also see that the holes are not run in parallel lines, the water leaves at an equal rate across the area of the head.
I used the thread from this design: https://www.thingiverse.com/thing:2693686
Everything else is designed from scratch.
I pushed the design to it's limit by printing with a 1.0mm printing nozzle and it held up perfectly, no leaking. Print yours with a smaller nozzle at a decent layer height and it will come out lovely! Some infill needed to reinforce the threaded area.
Happy gardening!
Category: Outdoor & Garden