Toothbrush Head Cup Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This slots over a cup side and holds up to two toothbrush heads. Designed for my Sonicare toothbrush heads. Helps drying
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
Toothbrush Head Cup Holder
This is meant to fit up to two toothbrush heads and fit over the side of a cup; the goal is to help dry out brush heads after use and washing without having that water pool in a cup. It was specifically designed for Philips Sonicare brush heads https://www.usa.philips.com/c-m-pe/toothbrush-heads and fits over the cup that came with the Sonicare. It should work for other brush heads that satisfy the dimensions below. The thinnest part of the brush head needs to fit in the slot entryway, and the thickest part (could be the brush itself) needs to exceed the slot width, ideally by a fair bit.
Key Dimensions
- Width of slot entryway 6.504 mm
- Width of slot 7.09 mm
- Width of holder that fits over the edge of a cup 4.99 mm
Printing Advice
I printed this with regular PLA with a water-resistant variant of the 0.15 mm Quality preset (notably this features 4 perimeters). The part is small enough and some of the features could benefit from the slower print process that the quality preset provides, and there are curved edges in the Z-axis that merit a 0.15 mm or better layer height.