1 / 3
Voron 0.1 Orbiter Blockhead Print Head and X-Carriage — zdjęcie 1
1 / 3

Voron 0.1 Orbiter Blockhead Print Head and X-Carriage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the Sherpa Blockhead Dragon print head to use Orbiter V2 extruder and stronger Dragon print head attachment.

Ocena
0 / 5
Polubienia
9
Pobrania
81
Wydruki
0
Wyświetlenia
1206
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Remix of the Sherpa Blockhead Dragon print head.

Changes:

  • Use Orbiter V2 extruder
  • Thicker blockhead for stronger hotend attachment
  • Four screws with washers to attach Dragon hotend. Washers spread load.
  • Heat set inserts to attach hotend fan.  

The thicker blockhead lowers hotend slightly so you may need to adjust position of Z axis limit switch.  Use longer M2.5x16mm screws to attach the Dragon hotend, ideally also use M2.5 washers.

Also included is a modified X-Carriage with 4 screws for the linear rail carriage (two M2x8mm, two M2x10mm). Can also use washers to distribute stress on the carriage.  The X-axis limit switch requires two self tapping screws to attach, instead of just one in the original design.

Print in ABS. I prefer to print with 100% infill on the blockhead and x-carriage.

Follow assembly instructions from the original Make: https://www.printables.com/model/213588-sherpa-blockhead-fan-system-for-voron-01 

…. and with 2 additional M3 heat set inserts for the hotend fan and customised length of bowden tube.


 

Tagi