PocketTRS Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an enclosure for Arno Puder's PocketTRS. It's an awesome project, so I thought I would show it a little love.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is an enclosure for Arno Puder's PocketTRS. It's an awesome project, so I thought I would show it a little love. there are 4 parts in total. two feet with pegs to be glued into the base, the base, and the lid. :) It's made to look like a TRS-80 Model 1 expansion interface. :) This was designed with the V2.1 in mind, but the differences between v2.1 and 2.2 should not make a difference, but I don't have one to test with. :). The base should hold both boards.
The top should be printed brim down, with supports so the finished side is up, for a better finish. The bottom should be printed bottom down, with supports for the opening in the back, you can clip these off after it prints. :) Printed on a CR-10, but it less than 8" wide so most printers should be able to handle it. :)
added NewBody and NewLid stl files as well, better fit for lid and body.
I added versions of the small enclosure with supports built in, and also another lid, with a slightly deeper lip, you might have to trip it a bit if you install a 3mm power led. :)
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
15 to 20
Filament: DigitMakers PLA Post-Printing =============
Just clip the supports in the openings. :)
Category: Computer